Dålig kontakt
From the above structure, the inside of the electrical connector metal conductor is the core of the whole equipment parts, is used to connect the external wire or cable of the electric pressure or the current, the data signal is equal to the mutual cooperation, mutual collocation is passed to the circular connector contact element, so the aviation connector design above must demand do fine structure, to have a very reliable stability and good electrical conductivity. Because this situation often happens, there are a lot of reasons, may be due to the contact parts of the plastic connector design is not reasonable, there are problems with the material selection, or the size of the processing is not in line with the design requirements, rough or unequal installation method, will cause the poor connection between the connector and the electrical equipment, so when the failure of electronic devices, the problem to consider is the contact problem, be sure to check all the joints, and then consider other problems under the condition of tight connection, if not the internal connection problem, through a Enkel plug- och infoga operation kan repareras mycket bra .
Dessutom bör uppmärksamheten ägnas åt skyddet av kontakten, i processen att använda detta är också mycket viktigt, ibland dålig kontakt på grund av felaktigt skydd av vid vanliga tider, vi skapade ett anslutning av partiell skada eller korrosion, detta leder till dålig kontakt är i allmänhet svårt att reparera, behovet av att ersätta anslutningen, är inte ett problem, är slöseri med resurser och ekonomiska förluster .}}}}}}}}}}}}}}}}}}}}}}}
Dålig isolering
Detta sägs främst att den yttre miljön, i allmänhet i detta fall kommer det att bli instabil prestanda, läckfenomen är mer fruktansvärt, kommer att orsaka användning av osäkra faktorer, mer intuitivt kan observeras, men när du stöter på ett sådant problem måste ett kontakt med kontakten och direkt ersätta de nya.}
Här kommer också ett problem som är orsaken till den defekta isoleringen, eftersom yta- eller inre isolatorutrustningens överskottsmaterial, såsom vanligt damm, spån och så vidare, adsorberar material under lång tid och kan orsaka fuktabsorption i isoleringen, åldrandet i en kortslutning, läckage, uppkomsten av fel, om de är undermåliga isoleringsmaterial. Om vi väljer fel, om det finns en situation orsakad av miljöpåverkan, orsakat av det olämpliga vi använder och skyddar det dåliga, särskilt fuktig miljö som korrosionsskador på kontaktisoleringen mer, låter oss mycket knytas samman, detta måste undvikas så långt som möjligt, annars orsakar det mer onödig förlust, särskilt läckageskydd, och kan involvera människors säkerhet. Därför bör man i användningstiden särskilt uppmärksamma skyddet av isolering, förhindra och kontrollera dålig isolering orsakad av fel.
Instabil
Due to poor fixation or slight shaking and so on can cause the connector power, more serious will also cause connection interruption, product disintegration. This can generally be avoided by changing the installation method, especially paying attention to the rationality of installation, installation and use of tight integration, this problem will not appear. Therefore, in the selection, should be as close as possible between the design of the connection between the requirements, the selection of relativt mogna produkter .







